In-situ detection of density alteration in non-physiological cells with polarimetric tilted fiber grating sensors


  • Guo, Tuan
  • Liu, Fu
  • Liu, Yu
  • Chen, Nan-Kuang
  • Guan, Bai-Ou
  • Albert, Jacques




Tilted fiber Bragg grating (TFBG) biosensors can be used as a cost-effective and relatively simple-to-implement alternative to well established biosensor platforms for high sensitivity biological sample measurements in situ or possibly in vivo. The fiber biosensor presented in this study utilizes an in-fiber 12° tilted Bragg grating to excite a strong evanescent field on the surface of the sensor over a large range of external medium refractive indices. The devices have minimal cross-sensitivity to temperature and their fabrication does not impact the structural integrity of the fiber and its surface functionalization. Human acute leukemia cells with different intracellular densities and refractive index (RI) ranging from 1.3342 to 1.3344 were clearly discriminated in-situ by using the differential transmission spectrum between two orthogonal polarizations for the last guided mode resonance before "cut-off", with an amplitude variation sensitivity of 1.8×10(4)dB/RIU, a wavelength shift sensitivity of 180nm/RIU, and a limit of detection of 2×10(-5)RIU. The detection process was precisely controlled with a micro-fluidic chip which allows the measurement of nL-volumes of bio-samples. The proposed in-fiber polarimetric biosensor is an appealing solution for rapid, sub-microliter dose and highly sensitive detection of analytes at low concentrations in medicine, chemical and environmental monitoring.



Peer Review: 

Published in Peer Reviewed Journal

Faculty Name: 

Faculty of Engineering and Design

Department Name: 

Department of Electronics

Items in CURVE are protected by copyright, with all rights reserved, unless otherwise indicated. They are made available with permission from the author(s).